Club Car 2008 Turf Maintenance And Service Manual page 52

5
ACCELERATOR AND BRAKE PEDAL GROUP
Pedal Group Adjustment – Gasoline Vehicles, Continued:
Figure 5-16 Brake Rod Adjustment
4. Adjust accelerator pedal height.
4.1. Loosen the nut and bolt (Figure 5-17, Page 5-14) securing the accelerator pedal to the pivot plate.
Clamp the accelerator pedal adjustment tool (CCI P/N 101871001) to the accelerator pedal, with
the end marked accelerator pedal height closest to the floorboard. Press the accelerator pedal until
the end of the tool rests against the floorboard; pedal height should be 5-5/8 inches (14.3 cm). Use
a rubber strap to hold pedal in position against the floorboard and then tighten nut to 26 ft-lb (35.3
N·m) (Figure 5-18, Page 5-14).
5. Adjust the accelerator rod. See following DANGER.
ý
DANGER
• Before servicing, turn the key switch to the OFF position and place the Forward/Reverse
handle in the NEUTRAL position.
• To prevent accidentally starting the vehicle, disconnect the battery cables as instructed in
WARNING "To avoid unintentionally starting..." in General Warning, Section 1, Page 1-2. This will
prevent the possibility of the vehicle running over you when you are adjusting the accelerator
rod.
Page 5-14 2008 Turf/Carryall Vehicle Maintenance and Service Manual
ACCELERATOR PEDAL
ADJUSTMENT TOOL
(CCI P/N 101871001)
Figure 5-18 Accelerator Pedal Height Adjustment
Pedal Group Adjustment – Gasoline Vehicles
1/2-INCH SOCKET
Figure 5-17 Accelerator Pedal Height Adjustment
RUBBER STRAP
1/2-INCH WRENCH