Club Car 2008 Turf Maintenance And Service Manual page 64

6
WHEEL BRAKE ASSEMBLIES
Brake Shoe Installation (Self-Adjusting Brakes), Continued:
NOTE: The trailing shoe has 17T stamped into the tip of the shoe flange (Figure 6-12, Page 6-6). The
leading shoe is stamped 17L. When installing the shoes, the stampings on both shoes should be
oriented to the top of the brake assembly. When installing the shoes on the passenger side of the
vehicle, the side of the trailing shoe flange marked 17T should be facing out and be visible. On the
driver side, the 17L on the leading shoe should be facing out and be visible.
When installed on the backing plate, the leading shoe (stamped 17L) is always oriented toward the
rear of the vehicle.
Figure 6-12 Trailing Shoe
2. Install the shoe retainer clip (1). Compress clip while turning retainer pin (2) into position (Figure 6-13,
Page 6-6).
3. Attach the springs onto the trailing shoe already installed. Hold the leading shoe next to the trailing shoe,
correctly oriented, and attach the springs to it (Figure 6-14, Page 6-6).
Figure 6-13 Retainer Clip
Page 6-6 2008 Turf/Carryall Vehicle Maintenance and Service Manual
Brake Shoe Installation (Self-Adjusting Brakes)
17T STAMPING
ON TRAILING
SHOE
1
2
SILVER SPRING
BRONZE SPRING
SPRING COILS
Note that the silver
spring is mounted with
the coils to the side of the
adjustment lever spring (A).
Figure 6-14 Spring Orientation
A