Brake Adjustment (Manually-Adjusted Brakes) - Club Car 2008 Turf Maintenance And Service Manual

6
WHEEL BRAKE ASSEMBLIES
Brake Shoe Installation (Manually-Adjusted Brakes), Continued:
Figure 6-25 Insert Shoes
ý
CAUTION
• Clean any residual oil from the exposed end of the axle shaft and from the oil seal area prior to
installing the axle shaft.
6. Install axle shaft (2) into axle tube and install retaining ring (1) (Figure 6-3, Page 6-2). See WARNING
on page 6-8.
7. Install the brake drum and make sure that it is properly seated. See following NOTE.
NOTE: If drum installation is difficult, the brake shoes may need to be adjusted vertically in the mounting
slots.
8. After the drum is installed, make sure the axle and drum turn freely.

BRAKE ADJUSTMENT (MANUALLY-ADJUSTED BRAKES)

See General Warning, Section 1, Page 1-1. See also Warning, on Page 6-1.
ý
CAUTION
• Pedal group adjustment must be within specifications prior to beginning brake adjustment.
Perform the appropriate pedal group adjustment.
- For gasoline vehicles, refer to Pedal Group Adjustment – Gasoline Vehicles, Section 5,
Page 5-11.
- For electric vehicles, refer to Pedal Group Adjustment – Electric Vehicles, Section 5,
Page 5-16.
NOTE: All brake cluster components must be clean, lubricated, and in good working condition prior to
beginning brake adjustment.
All wheels must be installed on the vehicle and lug nuts tightened to 55 ft-lb (74.6 N·m).
Page 6-12 2008 Turf/Carryall Vehicle Maintenance and Service Manual
Brake Adjustment (Manually-Adjusted Brakes)
Figure 6-26 Position Shoes
TIPS