Brake Shoe Installation (Manually-Adjusted Brakes) - Club Car 2008 Turf Maintenance And Service Manual

6
WHEEL BRAKE ASSEMBLIES
Brake Assembly Cleaning (Manually-Adjusted Brakes), Continued:
ý
WARNING
• Apply grease carefully when performing the following steps. Do not allow any grease to get
on the friction surfaces of the brake shoe pads. Failure to heed this warning could cause
diminished brake performance, possibly resulting in property damage or severe personal
injury.
4. Use a small brush to carefully apply a light coat of white lithium NLGI #2 grease (Dow Corning BR2-Plus
or equivalent) on each of the six raised bosses on brake backing plate (Figure 6-20, Page 6-9). See pre-
ceding WARNING.
5. Use a small brush to carefully apply a light coat of white lithium NLGI #2 grease (Dow Corning BR2-Plus
or equivalent) to each end of both brake shoes and into the slots in the brake shoe mounting block as
shown (Figure 6-21, Page 6-10). See preceding WARNING.
6. Use a small brush to carefully apply a light coat of white lithium NLGI #2 grease (Dow Corning BR2-Plus
or equivalent) to the brake actuator assembly as shown (Figure 6-22, Page 6-10). See preceding
WARNING.
Figure 6-21 Lubricate Shoes

BRAKE SHOE INSTALLATION (MANUALLY-ADJUSTED BRAKES)

See General Warning, Section 1, Page 1-1. See also Warning, on Page 6-1.
Turf 2, Carryall 2, 2 Plus, and 6 vehicles
NOTE: Components of the front wheel brake assembly are identical to the rear wheel manually-adjusted
brake assembly. The front brake assembly is rotated 90° (when compared to the rear brake
assembly) so the adjusting bolt on each assembly is oriented to the rear of the vehicle rather than
at the top of the assembly (Figure 6-32, Page 6-15).
Page 6-10 2008 Turf/Carryall Vehicle Maintenance and Service Manual
Brake Shoe Installation (Manually-Adjusted Brakes)
Figure 6-22 Lubricate Actuator