Wall-Mounting The At30 - HindlePower AT30 SERIES Operating And Service Instructions

INSTALLING THE AT30
1.5.2. Wall-Mounting the AT30 (Style-5018 enclosure only)
To install the AT30 onto a vertical surface, the standard Style-5018
enclosure does not need to be modified, but a special wall-mounting
accessory (EI5008-00) is required. For kit availability see ordering
information in Appendix B on page 65. The kit includes two (2)
mounting brackets, appropriate hardware, and Installation Instructions
(JA5063-00) for the wall-mounting procedure.
When wall-mounting the AT30, consider the following:
1. The wall must be strong enough to properly support the weight of the AT30
and the mounting brackets. Comprehensive weight data for the different
models is available in the AT30 product literature (JF5018-00). The
weight of your AT30 may be different from the literature value, depending
on supplied features, options, or accessories.
2. Be conscious of planned ac input and dc output wiring to the AT30,
selecting conduit entrances carefully. Note the standard pre-fab conduit
knockouts located on the sides the Style-5018 enclosure.
3. The location:
• Should be free of drips and splatter. If falling particles and liquids are a
problem, install NEMA-2 type drip shield accessory (EI0191-0#). For
kit availability, see ordering information in Appendix B on page 65.
• Should be between 0 and 122 °F / -18 and 50 °C, with relative humidity
between 5% and 95% non-condensing.
• Must be free of flammable or explosive materials.
4. Maintain at least 6in / 152mm of free air on all vented surfaces for cooling.
5. Allow at least 36in / 914mm front clearance for access to the AT30 for
operation and maintenance.
PROCEDURE
1. Install eight (8) 0.25in / 6.4mm anchor
bolts (not supplied) rated to support the
AT30 weight plus a safety factor of at
least two (2) times, into the wall.
2. Mount the triangular brackets to the wall.
3. Carefully lift the Style-5018 enclosure
onto the mounted triangular brackets.
4. Use the supplied 0.25in / 6.4mm hardware
to mount the enclosure to the wall-
mounting brackets and tighten securely.
5. Refer to the graphics on the opposite page
for the AT30 Style-5018 wall-mounting
pattern and enclosure footprint.
6. Dimensions are in/mm.
6