Test Ipv4 Or Ipv6 Network Configuration; Exit Oracle Ilom - Sun Oracle Fire X4170 M2 Installation Manual

▼ Test IPv4 or IPv6 Network Configuration

1. At the Oracle ILOM CLI prompt, type the show command to view the network
test targets and properties.
For example, see the following output the shows the test target properties.
-> show
/SP/network/test
Targets:
Properties:
ping = (Cannot show property)
ping6 = (Cannot show property)
Commands:
cd
set
show
2. Use the set ping or set ping6 command to send a network test from the
device to a specified network destination:
Property
ping
ping6

▼ Exit Oracle ILOM

●
To end an Oracle ILOM session, at the CLI prompt, type exit.
56 Sun Fire X4170 M2 and X4270 M2 Servers Installation Guide • January 2012
Set Property Value
set ping=<IPv4_address>
set ping6=<IPv6_address>
Description
Type the set ping= command at
the command prompt followed by
the IPv4 test destination address.
For example:
-> set ping=10.8.183.106
Ping of 10.8.183.106
succeeded
Type the set ping6= command
followed by the IPv6 test
destination address.
For example:-> set ping6=
fe80::211:5dff:febe:5000
Ping of
fe80::211:5dff:febe:5000
succeeded