Codabar Set Length 2 - Datalogic Powerscan PD7100 Product Reference Manual

Codabar — cont.

Codabar Set Length 2

This feature specifies one of the barcode lengths for
is the maximum label length if in
in
Fixed Length
characters. The length must include at least one data character.
The length can be set from 3 to 50 characters. A setting of 0 specifies to ignore this length
(only one fixed length).
Follow these instructions to set this feature:
1. Determine the desired character length (from 3 to 50 — or 0 to ignore this
2. Scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Program-
3. Scan the barcode: SELECT CODABAR LENGTH 2 SETTING.
4. Scan the appropriate two digits from the keypad in
5. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Program-
This completes the procedure. See
Table 30. Codabar Length 2 Setting Examples
STEP ACTION
Desired Setting (and pad with
1
leading zeroes)
2 Scan ENTER/EXIT PROGRAMMING MODE
3 Scan SELECT CODE 39 LENGTH 2 SETTING
Scan Two Characters From
4
Appendix E, Keypad
5 Scan ENTER/EXIT PROGRAMMING MODE
Product Reference Guide
Mode. The length includes the barcode's start, stop, check and data
length). Pad the number with leading zeroes to yield two digits. For example: 0 =
00, 5 = 05, 20 = 20, etc.
ming Mode.
resent the length setting which was determined in the steps above. You will hear a
two-beep indication after the last character.
If you make a mistake before the last character, scan the CANCEL barcode to
abort and not save the entry string. You can then start again at the beginning.
NOTE
ming Mode.
00 Ignore This
Length
'0' and '0'
Codabar Length Control
Mode, or the second fixed length if
Variable Length
Appendix E, Keypad
for some examples of how to set this feature.
Table 30
EXAMPLES
07 Characters 15 Characters
'0' and '7' '1' and '5'
Codabar
. Length 2
, that rep-
50 Characters
'5' AND '0'
239