Software Version Transmission; Resetting The Product Configuration To Defaults - Datalogic Powerscan PD7100 Product Reference Manual

Software Version Transmission

The software version of the device can be transmitted over the RS-232 and Keyboard in-
terfaces by scanning the following label.

Resetting the Product Configuration to Defaults

If you aren't sure what programming options are in your imager, or you've changed some
options and want to restore the Custom Default Configuration that may have been saved
in the imager, scan the
will restore the custom configuration for the currently active interface.
If you aren't sure what programming options are in your imager, or you've changed some
options and want to restore the Factory Configuration, you have two options. You can
scan the
Configuration
tory settings including the interface type. The USA label restores Label IDs to those his-
torically used in the USA. The EU label restores Label IDs to those historically used in
Europe. The Label ID sets for USA and EU are shown in the Label ID section of this
manual.
The programming section lists the factory default settings for each of the menu com-
mands (indicated by shaded blocks and bold text) on the following pages.
Product Reference Guide
Restore Custom Default Configuration
Custom defaults are based on the interface type. Configure the
imager for the correct interface before scanning this label.
NOTE
Restore Custom Default Configuration
Restore USA Factory Configuration
bar code below. Both labels restore the imager configuration to the fac-
Restore USA Factory Configuration
Restore EU Factory Configuration
Resetting the Product Configuration to Defaults
Transmit Software Version
bar code or the
barcode below. This
Restore EU Factory
9