Wedge Quiet Interval - Datalogic Powerscan PD7100 Product Reference Manual

Wedge Quiet Interval

This option specifies the amount of time to look for keyboard activity before the read-
er breaks the keyboard connection in order to transmit data to host. The selectable
range for this feature is from 0 to 990ms in 10ms increments.
Follow these instructions to set this feature:
1. Determine the desired setting in milliseconds.
2. Divide the desired setting by 10 (setting is in 10ms increments). Pad the result
3. Scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Program-
4. Scan the barcode: SELECT WEDGE QUIET INTERVAL SETTING.
5. Scan the appropriate two digits from the keypad in
6. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Program-
This completes the procedure to set the Wedge Quiet Interval. See
examples of how to set this feature.
Table 14. Timeout Setting Examples
STEP ACTION
1 Desired Setting
Divide by 10 (and pad with leading
2
zeroes)
3 Scan ENTER/EXIT PROGRAMMING MODE
4 Scan SELECT WEDGE QUIET INTERVAL SETTING
Scan Two Characters From
5
Appendix E, Keypad
6 Scan ENTER/EXIT PROGRAMMING MODE
Product Reference Guide
This feature applies ONLY to the Keyboard Wedge interface.
NOTE
with leading zeroes to yield two digits. For example: 0 = 00, 5 = 05, 20 = 20, etc.
ming Mode.
resent the duration which was determined in the steps above. You will hear a two-
beep indication after the last character.
If you make a mistake before the last character, scan the CANCEL barcode to
abort and not save the entry string. You can then start again at the beginning.
NOTE
ming Mode.
10ms
01
'0' and '1'
Appendix E, Keypad
EXAMPLES
150ms 600ms
15 60
'1' and '5' '6' and '0'
Wedge Quiet Interval
, that rep-
for some
Table 14
850ms
85
'8' and '5'
77