Datalogic Powerscan PD7100 Product Reference Manual page 132

Data Editing
conversion: BB22BB22.
The A characters were converted to B characters and the 1 characters were converted to
2 characters. Nothing is done with the last two character pairs, since they are all FF.
To set Character Conversion:
1. Scan the ENTER/EXIT barcode.
2. Scan the "Configure Character Conversion" barcode.
3. Determine the desired string. Sixteen positions must be determined as in the above
4. Turn to
5. Scan the ENTER/EXIT barcode to exit Programming Mode.
Character Conversion — continued
122
example. Next, turn to the ASCII Chart on the inside back cover of this manual
and find the equivalent hex digits needed to fulfill the string.
Appendix E, Keypad
ters determined in the previous step.
If less than the expected string of 16 characters are selected, scan
the ENTER/EXIT barcode twice to accept the selections and exit Pro-
gramming Mode.
NOTE
ENTER/EXIT PROGRAMMING MODE
DEFAULT
and scan the barcodes representing the hex charac-
Configure Character Conversion
0xFFFFFFFFFFFFFFFF
(No character conversion)
PowerScan TM PD7100 Corded