I 2 Of 5 Set Length 1 - Datalogic Powerscan PD7100 Product Reference Manual

Interleaved 2 of 5 (I 2 of 5) — cont.

I 2 of 5 Set Length 1

This feature specifies one of the barcode lengths for
the minimum label length if in
Fixed Length
The length can be set from 2 to 50 characters in increments of two.
Follow these instructions to set this feature:
1. Determine the desired character length (from 2 to 50). The length must be an
2. Pad the result with leading zeroes to yield two digits. For example: 0 = 00, 5 = 05,
3. Scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Program-
4. Scan the barcode: SELECT I 2 of 5 LENGTH 1 SETTING.
5. Scan the appropriate two digits from the keypad in
6. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Program-
This completes the procedure. See
Table 25. I 2 of 5 Length 1 Setting Examples
STEP ACTION
1 Desired Setting
Pad with leading zeroes to yield
2
two digits
3 Scan ENTER/EXIT PROGRAMMING MODE
4 Scan SELECT I 2 of 5 LENGTH 1 SETTING
Scan Two Characters From
5
Appendix E, Keypad
6 Scan ENTER/EXIT PROGRAMMING MODE
Product Reference Guide
Mode. The length includes the barcode's check and data characters.
even number.
20 = 20, etc.
ming Mode.
resent the length setting which was determined in the steps above. You will hear a
two-beep indication after the last character.
If you make a mistake before the last character scan the CANCEL barcode to
abort and not save the entry string. You can then start again at the beginning.
NOTE
ming Mode.
2 Characters
02
'0' and '2'
I 2 of 5 Length Control
Mode, or the first fixed length if in
Variable Length
for some examples of how to set this feature.
Table 27
EXAMPLES
6 Characters 14 Characters
06
'0' and '6'
Interleaved 2 of 5 (I 2 of 5)
. Length 1 is
, that rep-
Appendix E, Keypad
50 Characters
14 50
'1' and '4' '5' AND '0'
209