Programming - Datalogic Powerscan PD7100 Product Reference Manual

Other connection types are described below and illustrated in
USB Connection —
USB cable for the interface type you ordered. Reference
IBM Connection —
rect IBM cable. Reference
Keyboard Wedge Connection —
the reader. Connect the female to the male end from the keyboard and the remaining end at the
keyboard port at the terminal/PC. Reference
Wand Emulation Connection —
terminal/PC using the correct cable. Reference
Figure 2. Other Interface Connections

Programming

The reader is factory-configured with a set of default features standard. After scanning the inter-
face barcode from the
reader through use of the instructions and programming barcodes available in the corresponding
features section for your interface and also the Data Editing and Symbologies chapters of this
manual.
Product Reference Guide
Connect the reader to a USB port on the terminal/PC using the correct
Connect the reader to the IBM port on the terminal/PC using the cor-
Figure 2.
or...
Specific cables are required for connection to different hosts. The
connectors illustrated above are examples only. Actual connectors
may vary from those illustrated, but the steps to connect the reader
remain the same.
NOTE
Interfaces section, you can select other options and customize your
Figure
Figure
The Keyboard Wedge cable has a 'Y' connection from
Figure 2.
Connect the reader to the Wand Emulation port on the
Figure 2
or...
or...
Setting Up the Reader
2.
2.
7