Appendix B. Standard Defaults - Datalogic Powerscan PD7100 Product Reference Manual

The most common configuration settings are listed in the "Default" column of
The settings in this table are as applied to a standard RS-232 interface. See
a listing of default exceptions to this list as appled to other interface types. Page references
are also provided for feature descriptions and programming barcodes for each parameter.
A column has also been provided for recording of your preferred default settings for these
same configurable features.
Table 47. Standard Defaults
General Features
Double Read Timeout
Label Gone Timeout
Sleep Mode Timeout
Sleep Mode Timeout
Power On Alert
Good Read: When to Indicate
Good Read Beep Type
Good Read Beep Frequency
Good Read Beep Length
Good Read Beep Volume
Good Read LED Duration
Scan Mode
Scanning Active Time
Flash On Time
Flash Off Time
Stand Mode Sensitivity
Product Reference Guide
Standard Defaults
Parameter
Appendix B
Default Your Setting
0.4 Second
160 ms
Disable
Disable
4 Beeps
After Decode
Mono
Medium
80 ms
High
LED on until
next trigger pull
Trigger Single
5 Seconds
1 Second
600 ms
Medium
.
Table 47
for
Table 48
Page Number
17
19
21
21
23
24
25
26
26
28
29
31
35
37
39
41
339