Specific Tooling; Assembling The Clutch - MOTO GUZZI Stelvio 1200 NTX Service Manual

STELVIO 1200 NTX
•
Fit the gearbox on the engine block.
•
Fit the tool in the gearbox to determine
the clutch control rod length.
•
Measure rod protrusion using a depth
gauge (see picture).
•
According to the value found, select
the correct rod based on the following
table:

Specific tooling

020678Y Tool for clutch rod checking
Specification
Protrusion: 9.8 - 11.2 mm (0.386 - 0.441 in)
Protrusion: 8.3 - 9.7 mm (0.327 - 0.382 in)
Protrusion: 6.8 - 8.2 mm (0.268 - 0.323 in)
Protrusion: 5.3 - 6.7 mm (0.209 - 0.264 in)

Assembling the clutch

•
Lock crankshaft rotation with the
crankpin facing upwards.
•
Place the clutch disc with the reference
facing upwards.
•
Fasten the clutch disc on the crank-
shaft with the six screws, Loctite 243
and the belleville springs.
•
Place the clutch pressure plate.
•
Fit the tool to centre and compress the
plate.
•
Fully tighten the two centring tool
screws.
Specific tooling
020672Y Clutch spring centre and pusher
Revente Interdite - Revendita Vietata - Resaling Forbiden - Wiederverkauf Verboten
CLUTCH CONTROL ROD SELECTION
Clutch control rod length (code 976593) = 183 mm (7.205 in)
Clutch control rod length (code 976594) = 184.5 mm (7.264 in)
Clutch control rod length (code 976595) = 186 mm (7.323 in)
Clutch control rod length (code 976596) = 187.5 mm (7.382 in)
Desc./Quantity
ENG - 127
Engine