MOTO GUZZI Stelvio 1200 NTX Service Manual page 147

STELVIO 1200 NTX
Measuring air gap
•
Undo and remove the two screws and
remove the sensor.
•
Insert a suitable plain washer on the
sensor and note its thickness.
•
Place the sensor on the crankcase and move it until it makes contact with the tone wheel.
•
Measure the clearance between the fixing plate and the crankcase with a thickness gauge.
Subtract the plain washer value from this measurement to obtain the clearance between the
sensor and the tone wheel.
•
Remove the washer and fit the sensor after applying adequate sealing paste on the fixing
plate, then tighten the screws to the prescribed torque.
Revente Interdite - Revendita Vietata - Resaling Forbiden - Wiederverkauf Verboten
Engine
ENG - 147