Recording & Event Setup; Recording Mode Setup - EverFocus NVR User Manual

Conn. Status: The status of the connection. Click the Connect or

Disconnect button to change the connection status.
Rec. Status: The set recording schedule of this camera in this time.

Framerate: The frame rate of this camera.

Bitrate: The transmission bit rate of this camera.

Estimated Remaining Recording

recording time is dividing the current free capacity by dynamic total
bitrate.
If your total bitrate becomes red, it means that the loading of the system is too heavy.
2.2 Recording & Event Setup

2.2.1 Recording Mode Setup

1. Open Internet Explorer and log in to the unit.
2. Click Settings / Recording & Event / Recording settings.
3. Click the Recording Mode tab.
4. If selecting Always Recording, the chosen cameras will begin to record
immediately.
No Recording: Turn off the recording.

Recording by

Always Recording: Permanently turn on the chosen cameras.

Schedule: Recording by schedule.
Time: Estimated remaining
23