Revision History - Dalsa SG-10-01k80 User Manual

Spyder3 GigE User's Manual

Revision History

Revision
Number
00
01
02
03
04
DALSA
PRELIMINARY
Change Description
Initial release
Specification updates to Table 2.
Updated Section 3.2 to show different methods of entering ASCII commands.
Updated Section 3.4 replacing TBDs with values.
Updated Section 4.1 to show inverted GPIO connector.
Updated Help Screen in C amera ASCII Command Help section to show latest
3 2 0 H
configuration of commands.
Added line rate ranges to Setting the Line Rate section.
Added sgi command.
Removed Vertical Binning from example gcp screen in section A4.6.
Updated random noise, PRNU, SEE, NEE, and DC Offset specifications in
Table 2.
Updated step 3 in section 2.1 Installation Overview with new driver installation
tool instructions.
Added that Windows 2000 with SP4 installed is necessary in section 2.2 PC
Requirements.
In section A1.1 Sensitivity Mode, corrected values for high and low sensitivity
modes.
In section A1.4 Setting the Exposure Mode updated exposure mode factory
setting from 2 to 7.
On page 65, in Calibrating Camera Gain and in Table 10: Command Quick
Reference, updated algorithm 4.
In section A3 Saving and Restoring Settings, added more detail about the
different sets of user settings and pixel coefficients.
Added cpa command to section
Chain and A SCII Commands: Reference
3 2 2 H
Removed sgs command and updated sgi and sgo commands in section
Configuring the GPIO Connector and ASCII Commands: Reference.
Added PRNU ECD specs to Table 2 and updated FPN global, PRNU ECD and
DC offset specs.
Section 2.1 Installation Overview: screenshots and procedure updated to reflect
current version of the QuickCam GUI.
Section 2.2 Equipment Recommendations: Ethernet shielded cable information
added.
Section 2.4 Camera Connectors: Ethernet shielded cable information added.
Appendix C
A 2.2 Analog and Digital Signal Processing
3 2 1 H
107
A 1.5
3 2 3 H
03-032-10158-04