Dalsa SG-10-01k80 User Manual page 103

Spyder3 GigE User's Manual
Message
Warning 05: Can't
set LVDS for this
GPIO signal
Warning 07:
Coefficient may be
inaccurate A/D
clipping has
occurred>
Warning 08: Greater
than 1% of
coefficients have
been clipped>
Warning 09: Internal
line rate inconsistent
with readout time>
Message
Error 02:
Unrecognized
command>
Error 03: Incorrect
number of
parameters>
Error 04: Incorrect
parameter value>
Error 05: Command
unavailable in this
mode>
Error 06: Timeout>
Error 07: Camera
settings not saved>
Error 08: Unable to
calibrate - tap
outside ROI>
Error 09: The
camera's
temperature exceeds
the specified
operating range>
DALSA
PRELIMINARY
Description
Input 3 and Output 3 cannot be set to use an LVDS signal.
In the region of interest (ROI) greater than 6.251% single or 1% of
averaged pixel values were zero or saturated.
A FPN/PRNU has been calculated to be greater than the maximum
allowable 511 (8).
Description
Command is not available in the current access level or it is not a valid
command.
This response returned for
· Alpha received for numeric or vice versa
· Not an element of the set of possible values. E.g., Baud Rate
· Outside the range limit
Command is valid at this level of access, but not effective. Eg line rate
when in smart Exsync mode
Command not completed in time. Eg FPN/PRNU calculation when no
external Exsync is present.
Tried saving camera settings ( rfs / rus) but they cannot be saved.
Cannot calibrate a tap that is not part of the region of interest.
Indicates that the camera has shut itself down to prevent damage from
further overheating.
103
03-032-10158-04