Dalsa SG-10-01k80 User Manual page 99

Spyder3 GigE User's Manual
Mnemonic
get status led
help
load pixel coefficients
reset camera
restore factory settings
region of interest
reset pixel coeffs
restore user settings
set analog gain
set analog offset
set binning horizontal
DALSA
PRELIMINARY
Syntax Parameters
gsl
h
lpc
rc
rfs
roi
x y x y
rpc
rus
sag
t f
sao
t i
sbh
m
Description
Returns the current state of the
camera's LED where:
1 = Red
2 = Green
5 = Blinking green
6 = Blinking red
Display the online help. Refer to
C amera ASCII Command Help on page
3 1 8 H
5 3 for details.
3 1 9 H
Loads the previously saved pixel
coefficients from non-volatile memory
where i is:
0 = Factory calibrated coefficients
1 = Coefficient set one
2 = Coefficient set two
3 = Coefficient set three
4 = Coefficient set four
Resets the entire camera (reboot). Baud
rate is not reset and reboots with the
value last used.
Restores the camera's factory settings.
FPN and PRNU coefficients reset to 0.
Sets the pixel range affected by the cag ,
cao , gl , gla , ccf , and ccp commands.
The parameters are the pixel start and
end values ( x ) and the column start and
end values ( y ) in a range from 1 to
sensor pixel count .
Resets the pixel coefficients to 0.
Restores the camera's last saved user
settings and FPN and PRNU
coefficients.
Sets the analog gain in dB.
t = tap selection, either 1 or 2
depending on camera model, or 0 for
all taps.
f = gain value specified from –10 to
+10
Sets the analog offset.
t = tap selection, either 1 or 2
depending on camera model, or 0 for
all taps.
i = Offset value in a range from 0 to
255 (12-bit LSB). Offset increases with
higher values.
Sets the horizontal binning value.
Available values are 1 and 2 .
03-032-10158-04
99