Dalsa SG-10-01k80 User Manual page 98

98
Mnemonic
end of line sequence
enable pixel coefficients
get camera model
get camera parameters
get camera serial
get camera version
get fpn coeff
get help
get line
get line average
get prnu coeff
get signal frequency
03-032-10158-04
PRELIMINARY
Syntax Parameters
els
i
epc
i i
gcm
gcp
gcs
gcv
gfc
x
gh
gl
x x
gla
x x
gpc
x
gsf
i
Spyder3 GigE User Manual
Description
Sets the end-of-line sequence:
0 : Off
1 : On
Sets whether pixel coefficients are
enabled or disabled.
The first parameter sets the FPN
coefficients where i is:
0 = FPN coefficients disabled
1 = FPN coefficients enabled
The second parameter sets the PRNU
coefficients where i is:
0 = PRNU coefficients disabled
1 = PRNU coefficients enabled
Reads the camera model number.
Reads all of the camera parameters.
Read the camera serial number.
Read the firmware version and FPGA
version.
Read the FPN coefficient
x = pixel number to read in a range
from 1 – sensor pixel count .
Returns all of the available "get"
commands.
Gets a line of video (without pixel
coefficients applied) displaying one
pixel value after another and the
minimum, maximum, and mean value
of the sampled line.
x = Pixel start number
x = Pixel end number
in a range from 1 to sensor pixel
count .
Read the average of line samples.
x = Pixel start number
x = Pixel end number
in a range from 1 to sensor pixel
count .
Read the PRNU coefficient.
x = pixel number to read in a range
from 1 – sensor pixel count .
Reads the requested Camera Link
control frequency.
1 = EXSYNC frequency
2 = Spare
3 = Direction
4 = Spare
DALSA