72
Setting Digital Offset
Purpose:
Syntax:
Syntax Elements:
Notes:
Related Commands:
Example:
PRNU Correction
03-032-10158-04
PRELIMINARY
Sets the digital offset. Digital offset is set to zero when you
perform FPN correction (
perform FPN correction, you can partially remove FPN by
adjusting the digital offset.
sdo t i
t
Tap selection. Allowable range is 1 to 2 depending on
camera model, or 0 for all taps.
i
Subtracted offset value in a range from 0 to 2048 where
FPN Coefficient= i (12 bit LSB Justified)
•
When subtracting a digital value from the digital video
signal, the output can no longer reach its maximum unless
you apply digital gain using the
previous section for details on the
s sg
9 1 H
sdo 0 100
Spyder3 GigE User Manual
command). If you are unable to
c cf
8 8 H
command. See the
s sg
8 9 H
command.
s sg
9 0 H
DALSA