Dalsa SG-10-01k80 User Manual page 95

Spyder3 GigE User's Manual
Syntax
get svm
Parameters:
t = tap id
get ugr
i = integer value
f = float
m = member of a set
get vt
s = string
x = pixel column number
y = pixel row number
get vv
get wfc
get wpc
get wus
ASCII Commands: Reference
The following table lists all of the camera's available ASCII commands. Refer to
Appendix A for detailed information on using these ASCII commands.
Table 14: Command Quick Reference
Mnemonic
calibrate analog offset
correction calibrate fpn
DALSA
PRELIMINARY
Parameters Description
Returns the current video mode.
0 : Normal video mode
1 : Test pattern
2 : Test pattern
Returns the gain reference value.
t
t = tap selection, either 1 to 2 depending on camera
model, or 0 for all taps
Returns the camera's internal chip temperature in degrees
Celsius.
Returns the camera's supply voltage.
Returns whether FPN coefficients have been saved.
0 = No FPN coefficients saved
1 = Pixel coefficients have been saved
Returns whether PRNU coefficients have been saved.
0 = No PRNU coefficients saved
1 = Pixel coefficients have been saved
Returns whether user settings have been saved.
0 = No user settings saved
1 = User settings have been saved
Syntax Parameters
cao
t i
ccf
Description
Calibrates the analog gain and averages
each tap's pixels within the ROI to the
specified average target value.
t = tap selection, either 1 or 2
depending on camera model, or 0 for
all taps
i = target value in a range from 1 to
255 DN (12 bit LSB)
Performs FPN calibration and
eliminates FPN noise by subtracting
away individual pixel dark current.
03-032-10158-04
95