Dalsa SG-10-01k80 User Manual page 100

100
Mnemonic
set baud rate
set ccd direction
set data mode
set digital offset
set exposure mode
set exposure time
set fpn coeff
03-032-10158-04
PRELIMINARY
Syntax Parameters
sbr
i
scd
i
sdm
i
sdo
t i
sem
m
set
f
sfc
x i
Spyder3 GigE User Manual
Description
Set the speed of camera serial
communication port. Baud rates: 9600 ,
19200 , 57600 , and 115200 . Default:
9600.
Sets the CCD shift direction where:
0 = Forward CCD shift direction.
1 = Reverse CCD shift direction.
2 = Externally controlled direction
control via CC3.
Sets the camera's bit width where:
For SG-10-01K40 and SG-10-02K40
0 = 8 bits, 1 tap, 40MHz data rate
1 = 12 bits, 1 tap, 40MHz data rate
For SG-10-01K80 and SG-10-02K80
2 = 8 bits, 2 taps, 80Mhz data rate
3 = 12 bits, 2 taps, 80MHz data rate
Subtracts the input value from the
video signal prior to FPN correction.
t = tap selection, either 1 or 2
depending on camera model, or 0 for
all taps.
i = Offset in a range from 0 to
2048 DN.
Sets the exposure mode:
2 = Internal SYNC, internal PRIN,
programmable line rate and exposure
time using commands ssf and set
3 = External SYNC, internal PRIN,
maximum exposure time
4 = Smart EXSYNC
5 = External SYNC and PRIN
6 = External SYNC, internal PRIN,
programmable exposure time
7 = Internal programmable SYNC,
maximum exposure time. Factory
setting.
8 = Internal SYNC, internal PRIN,
programmable exposure time.
Maximum line rate for exposure time.
Sets the exposure time. Refer to the
camera help screen ( h command) for
allowable range.
Set the FPN coefficient.
x =pixel number within the range 1 to
sensor pixel count .
i = FPN value within the range 0 to
2047 (12-bit LSB).
DALSA