Dalsa SG-10-01k80 User Manual page 94

94
Syntax
get sem
get set
get sfc
get sgi
get sgo
get slt
get spc
get ssb
get ssf
get ssg
get ssm
get sut
03-032-10158-04
PRELIMINARY
Parameters Description
Returns the current exposure mode:
2 = Internal SYNC, internal PRIN, programmable line
rate and exposure time using commands ssf and set
3 = External SYNC, internal PRIN, maximum exposure
time
4 = Smart EXSYNC
5 = External SYNC and PRIN
6 = External SYNC, internal PRIN, programmable
exposure time
7 = Internal programmable SYNC, maximum exposure
time. Factory setting.
8 = Internal SYNC, internal PRIN, programmable
exposure time. Maximum line rate for exposure time.
Returns the current exposure time in µs.
Returns the FPN coefficient for the pixel number idicated.
x
x =pixel number within the range 1 to sensor pixel
count .
Returns the current input signal setting for the input
i
number specified where:
0 = disabled
1 = TTL
2 = LVDS
Returns the current output signal setting for the output
i
number specified where:
0 = disabled
1 = TTL
2 = LVDS
Returns the current lower threshold value.
Returns the PRNU coefficient for the specified pixel
x
number.
x =pixel number within the range 1 to sensor pixel
count .
Returns the current background subtract value.
t
t = Tap value. 0 for all taps or 1 to 2 for individual tap
selection depending on camera model.
Returns the current line/frame rate in Hz.
Returns the current digital gain setting.
t
t = tap selection, either 1 to 2 depending on camera
model, or 0 for all taps
Returns the current sensitivity mode where:
0 = Low sensitivity mode
1 = High sensitivity mode
2 = Tall pixel mode
Returns the current upper threshold value.
Spyder3 GigE User Manual
DALSA