108
Revision
Number
03-032-10158-04
PRELIMINARY
Change Description
Section 3.3 First Power Up Camera Settings: 500 Hz line rate changed to 5000
Hz. Note concerning FPN and PRNU coefficients' factory calibration change
from 3.5 kHz line rate to 5 kHz.
Section 4: Electrical interface information, including EMC requirements and
shielded cable information, added to optical and mechanical considerations.
Section 6.3 Product Support form: Control signals section changed to reflect
GigE requirements.
Section A4.1 Ethernet test pattern revised. Ethernet test pattern only available
using the QuickCam application.
Section A4.7 Returning Camera Settings: GCP Screen updated.
Appendix B: EMC Declaration of Conformity: "Pending" stamp removed.
Products covered by the declaration and EMC requirements listed.
Spyder3 GigE User Manual
DALSA