Direct Connection To A Computer; Web Configuration Access - TIPTEL .com 410 Installation Manual

Configuration access

Direct connection to a computer

If you do not have a network you can also connect the telephone system directly to a
computer which has a network adapter integrated. In this case connect the LAN port
of the telephone system with the LAN port of your computer by using the attached
network cable. After that power up the telephone system her, wait for three minutes
and then start up your computer.
The telephone system's IP address now is 192.168.34.100. Your computer has auto-
matically been assigned with an IP address in this network range by your telephone
system.

Web configuration access

Now start your web browser and enter the IP address of your telephone system in the
address bar. So not use "www".
In the picture below the telephone system's IP address set via a telephone was
192.168.1.35. Instead of this address you must enter the IP address set by you, or - in
case the computer has been directly connected to your telephone system - you must
enter the factory default address 192.168.34.100.
A window for entering username and password will pop up. As factory default setting
both is admin. After entering username and password the web configuration can be
accessed.
33