Table of Contents
Advertisement
17.11.1
Scrolling Speed
Controls the rate the Fish Finder scrolls and updates the Fish Finder display.
17.11.2
White Line
Controls how the bottom type (hard or soft) is shown on the display. When the White Line
is Off the bottom return will display as red. When the White Line is On it can be used to
determine bottom hardness.
The White Line option is not available in the 50 & 200 kHz page.
17.11.3
Fish Symbols
Controls the graphical representation of underwater-suspended targets.
Echo
Icon + Echo
Icon + Echo + Depth : shown as arches with the Fish icon and relative depth values
Echo + Depth
Icon
Icon + Depth
17.11.4
A-Scope
Shows the real time display of the echo from the bottom.
17.11.5
Water Temperature
Allows selection between:
a. the temperature sensor in the depth transducer
or
b. an external temp sensor connected to the Optional Connection wires.
17.12 TRANSDUCER SETUP
This menu allows you to calibrate the speed through the water, water temperature and the
keel/prop offset of the transducer.
CP190i and CPF190i
: shown as arches (echoes)
: shown as arches with the Fish icon
: shown depth values
: shown as Fish icons without the arches
: shown as Fish icons and their relative depth values (shown accord-
ingly to currently selected depth unit)
Figure 17.12 - Transducer Setup menu
NOTE
Page 123
Advertisement
Table of Contents
