Table of Contents
Advertisement
a. Function not Activated
b. Not connected/detected : possible wiring problem, confirm wires are correct con-
c. Connected
d. Signal Lost
e. No valid GPS position
See the following example of About page:
16.3
MOBILARM PTX
A PTX is the Personal Transponder device that is worn by the crew. If a crew member falls
in the water the MOBILARM sends a signal to the GPS Chart Plotter which creates and
displays a PTX icon on the Chart page.
16.3.0 MOBILARM MOB alert is received
When crew member falls in the water, the MOBILARM sends a signal to the GPS Chart
Plotter which creates and displays a PTX MOB icon on the Chart page.
On the GPS Chart Plotter all menus and/or pages are closed and the chart is centered on
the PTX MOB received position. A Audible Alarm is heard and a popup warning window
appears to notify that a PTX has been received:
CP190i and CPF190i
: MOBILARM has not been setup in the I/O Connections
menu. Refer to Par. 16.1.
nected from the GPS Chart Plotter to the MOBILARM
device.
: the communication with MOBILARM device is Ok.
: the MOBILARM has been connected in the past, however
no signal is being detected from the MOBILARM. Check
wire connections from the GPS Chart Plotter to the
MOBILARM.
: the communication with MOBILARM device is Ok, but the
GPS position fix is not received from the GPS Chart
Plotter.
Figure 16.2 - Example of About page with MOBILARM information
Figure 16.3.0 - The PTX icon
Page 107
Advertisement
Table of Contents
