Table of Contents
Advertisement
84
Configuring the Forum 523/524
Proceed as follows:
1. In the Configurator, call up the System: Restart menu.
2. Click on Restart with Defaults.
3. Confirm this by pressing "OK" when the query dialogue box
opens.
Basic Hardware Settings Switch
The Forum 523/524 configuration can also be returned to the fac-
tory settings by means of the basic hardware settings switch.
Please note: If the factory settings are restored, all customer
settings and user data will be lost.
To restore the Forum 523/524 basic settings, proceed as
described in the following paragraphs.
1. Switch off the Forum 523/524 by disconnecting the power
plug.
2. Remove the cover (see Opening and Closing Forum 523/524).
CAUTION!
Static charges can damage electronic devices. Observe the
regulations regarding electrostatically sensitive compo-
nents.
3. The basic settings switch is designed as a key switch. The
location of the switch can be found in the chapter entitled
Interface Cards starting on page 40. Press and hold the switch.
4. Replace the power plug in the mains socket. Wait about 30
seconds until the indicator on the front of the Forum 523/524
constantly flashes.
5. Release the key switch.
The system data is now reset.
6. Push the cover all the way down.
Configuration
Advertisement
Table of Contents
