Table of Contents
Advertisement
104
Quick Start
External SIP Line
If your Forum 523/524 provides access to the Internet, you can
an easily and quickly set up an SIP line.
1. Request at least one SIP account from an SIP provider.
2. Install a Media Gateway card (see MGW Interface Card starting
on page 116).
3. Call up the Configurator and go to the page Telephony:
Ports: Slots. Click on the corresponding slot. Under
Configured, select MGC VoIP. Optional: enter an IP address
from the Forum 523/524 IP network which is not being used,
such as 192.168.99.253 under IP Address Configured. Click
on Apply.
4. Call up the Configurator and go to the page Telephony:
Trunks: SIP Provider. If your SIP provider is not listed, click
on New. Otherwise select the preconfigured SIP provider.
Enter the Name and Domain (DNS name of the SIP ID). Enter
the SIP server's IP address under Proxy/Registrar and an IP
address under STUN Server and STUN Port where
necessary. You can obtain more information on this from your
SIP provider. Click on Apply.
5. On the Telephony: Trunks: SIP Trunks page, click on New.
Activate the Status and enter a name for the account under
Name. Select the SIP Provider. Enter the relevant account
information under User name, Password, Phone No. and
SIP ID. Click on Apply.
The SIP ID setting will be used while logging in to the SIP
provider. Die Phone No. setting denotes the external phone
number used within the public phone network. You can enter
this number here to support system administration.
6. Call up the Telephony: Trunks: Route: New page once
again. Enter "SIP", for example, under Name, under Code the
number "8" and select the SIP account that was just
configured for Bundle/SIP trunks 1. The SIP account is now
available with the dialling prefix "8". To use the SIP account by
default, call up the page Telephony: Trunks: Route and
select the route External trunk. Under Bundle/SIP trunks
1, select the SIP account you have just set up. Click on Apply.
Voice over IP (VoIP)
Advertisement
Table of Contents
