Table of Contents
Advertisement
204
Using the Systray Display
Using the Systray Display
You can configure a systray display for the Forum 523/524 to
appear in the information area of the Start bar of a workstation
computer. This systray display constantly shows you whether a
WAN, a RAS or a Branch connection via ISDN is active. It is also
possible to display the current occupancy of the trunk lines.
Requirements
To use the systray display, you must first install TAPI; see Setting
up TAPI Interface starting on page 209.
Please note: The systray display requires a current version of
TAPI. If you are using TAPI from an earlier version of the
Forum 523/524, you must first install the newer version from the
product CD.
Installing the Systray Display
1. Call up the start mask of the product CD (see Configuring the
PC Software on page 203).
2. From the start mask, select Software: Install Systray.
Follow the programme instructions.
3. Start the programme with Start: Run and the configuration
dialogue is displayed. Select one of the entries displayed under
Existing PBXs. Enter your user name and password in the
boxes under Log-on.
4. If you activate the Autostart check box, you will see the
systray display even after restarting your workstation
computer.
5. Confirm the entries in the configuration dialogue with OK and
the systray display logs on for the Forum 523/524.
6. Right-click on the systray display in the Start bar.
Select Configuration to call up the configuration
dialogue. Select Network Connections or Trunk
Lines to produce a status dialogue.
Configuring the PC Software
Advertisement
Table of Contents
