224
DECT
Call up the Telephony: Trunks: Trunk group page. Change the
desired Q.SIG bundle and enter the line seizure code for the call-
back in the Prefix for source phone number at incoming
internal input field.
Question: Why is it not possible to reach a communications
system indirectly via another communications system?
You have interconnected e.g. three communications system with
two direct Q.SIG connections. While configuring the routes, you
applied the default "Business" selection for the Type setting. Call-
switching for internal calls is possible for the in-between commu-
nications system for internal routes only. Change the Type setting
for all affected routes to "Internal".
DECT
Question: The LED of the Forum base station is flashing, but
none of the DECT devices is functioning.
Make sure the terminal setting for the corresponding U
port is
pn
set to an Forum base station (Configurator, Telephony: Ports:
U
menu).
pn
If multiple Forum base stations are installed, the blinking LED
indicates that synchronisation is not finished.
Question: The LED of the Forum base station is continuously lit
up, but one of the cordless DECT devices is indicating
"No connection".
You have not registered this DECT device. Configure a port in the
Configurator and start the enrolment procedure (Telephony:
Devices: DECT Phones menu).
Question: Is it possible to increase the time for the enrolment
procedure?
You must manually enter the IPEI of the DECT device in the Con-
figurator. The enrolment time is then increased to one hour
(Telephony: Devices: DECT Phones menu).
Frequently Asked Questions