Service Call Conditions - Ricoh M052 Service Manual

6. TROUBLESHOOTING

6.1 SERVICE CALL CONDITIONS

6.1.1 SUMMARY
There are 4 levels of service call conditions.
Level
To prevent damage to the machine, the main
machine cannot be operated until the SC has
A
been reset by a service representative (see
the note below).
SCs that disable only the features that use the
defective item. Although these SCs are not
B shown to the user under normal conditions,
they are displayed on the operation panel only
when the defective feature is selected.
The SC history is updated. The machine can
C
be operated as usual.
Turning the main switch off then on resets SCs
D displayed on the operation panel. These are
re-displayed if the error occurs again.
When a Level "D" SC code occurs
When a Level D SC occurs, a screen opens on the operation panel to tell the operator:
An error occurred
The job in progress will be erased
The machine will reboot automatically after approximately 30 seconds.
The operator can wait until the machine reboots automatically or touch "Reset" on the screen to
reset the machine immediately and go back to the copy screen.
SM
Definition
6-1
Service Call Conditions
Reset Procedure
Enter SP mode, go into
SP5810, press [Execute], turn
the main power switch off and
on.
Turn the operation switch or
main switch off and on.
The SC will not be displayed.
Only the SC history is
updated.
Turn the operation switch off
and on.
M052/M053/M054