Vehicle System Test: Perform Test - Volkswagen Golf 2004 Service Manual

Golf 2004 ➤ , Golf Plus 2005 ➤
Maintenance - Edition 11.2009
Note
The following work description applies to the front left window
regulator. Reactivate the other window automatic functions in the
same manner by operating the respective switch in the driver
door.
– Switch on ignition.
– Close all doors and windows completely.
– Hold the front left side window in "closed" position, by pulling
and holding switch for longer than 1 second.
– Pull switch again for 1 second. The side window must now go
up or down by itself when switch is briefly pulled or pressed.
– Switch off ignition.
4.16

Vehicle system test: Perform test

– Connect vehicle diagnostic tester
– Switch on ignition.
– Select operating mode "Guided fault finding" on display.
– Then perform vehicle identification on vehicle diagnostic test‐
er .
The programme now automatically performs a vehicle system test
and reads all control units available for this vehicle type.
– Press button.
>
Now all faults are listed.
Note
At this point it is useful to change to operating mode guided
♦
functions to carry out further operations with diagnostic tester
and to prevent a second vehicle identification on vehicle diag‐
nostic tester .
To do this, press button operating mode and then guided func‐
♦
tions.
For further procedure see respective work descriptions.
♦
To return to guided fault finding, press button operating mode
♦
and then guided fault finding.
Caution
The vehicle must always be delivered to the customer with fault
memory cleared.
Static faults
If one or more static faults are found in the fault memory, we rec‐
ommend in agreement with the customer to rectify these faults
using guided fault finding.
Sporadic faults
If only sporadic faults or notes are stored in the fault memory and
the customer has no complaints in conjunction with the electronic
vehicle system, clear fault memory.
62
4. Descriptions of work
⇒ page 32 .