Volkswagen Golf 2004 Service Manual page 99

– First disengage engine cover at securing points -arrows 3- and
then at securing points -arrows 4- and raise.
Installing
Note
Dot not grease or lubricate rubber buffers of engine cover panel
before installation.
Install in reverse order.
4.26.6 Renewing rubber buffers for engine cov‐
er panel
Only Golf GTI "Edition 30" and Golf GTI "Pirelli"
Note
The rubber buffers for engine cover panel are renewed every
60,000 km in conjunction with air filter change for the Golf GTI
"Edition 30" and Golf GTI "Pirelli".
– Remove engine cover as described
– Place engine cover with upper side on a soft surface to prevent
damage to chrome applications.
– Pull rubber buffers -arrows- for engine cover panel out up‐
wards.
– Push new rubber buffers into guides.
Note
Dot not grease or lubricate rubber buffers of engine cover panel
-arrows- before installation.
Install engine cover in reverse order.
4.26.7 Removing and installing engine cover:
2.0 l FSI petrol direct injection engines
Removing:
– Unclip engine cover at securing points -arrows- and remove
upwards.
Installing:
Install in reverse order.
⇒ page 93
Golf 2004 ➤ , Golf Plus 2005 ➤
Maintenance - Edition 11.2009
4. Descriptions of work
95