Volkswagen Golf 2004 Service Manual page 101

– Pull connector -C- off air mass meter, and place connector to
side.
– First disengage engine cover at securing points -arrows A- and
carefully remove from fastenings.
– Slightly raise engine cover at front.
– Then disengage engine cover at securing points -arrows B-
and carefully remove from fastenings.
– Carefully remove engine cover upwards -movement arrows-.
Note
Ensure that the air mass meter is not damaged when removing
the engine cover.
Installing
– First fit engine cover onto rear securing points -arrows B-, then
onto front securing points -arrows A-.
Carefully press on securing points by hand until the engine cover
noticeably engages.
Note
Ensure that the air mass meter is not damaged when fitting
♦
the engine cover.
The remaining assembly steps are basically a reverse of the
♦
dismantling procedure.
4.26.10 Removing and installing engine cover:
1.9 l PD diesel engines
Note
There are different versions of engine covers:
♦
1. One-piece engine cover
♦
2. Two-piece engine cover
♦
One-piece engine cover:
Removing:
– Pull out dipstick -1-.
– Disengage engine cover -arrow 2- and lift.
– Then pull off forwards -arrow 3-.
Golf 2004 ➤ , Golf Plus 2005 ➤
Maintenance - Edition 11.2009
4. Descriptions of work
97