Volkswagen Golf 2004 Service Manual page 117

♦ Hub cap
♦ Full wheel trim
– Remove the respective wheel bolt cover, if fitted.
Note
The puller hook to remove the cover caps or the wheel hub trim
is located in the vehicle tool kit.
Example, removing hub cap
– Hook puller hook into one drilling of wheel hub trim and pull off
in -direction of arrow-.
Fitting instructions
Note
The cover caps protect the wheel bolts and should be recon‐
♦
nected after the wheel securing bolts have been retightened.
Ensure that on some rims the lug of the wheel hub trim locates
♦
in the groove of the rim.
Place puller hooks and adapter with vehicle tool kit after com‐
♦
pleting work.
– On vehicles with full wheel trim install full wheel trim so that
the tyre filler valve is guided through the cut-out provided
-arrow-.
Loosening or tightening anti-theft wheel bolts
Note
The adapter to loosen and tighten the anti-theft wheel bolts
♦
can be found in the vehicle tool kit.
If the adapter to loosen or tighten the anti-theft wheel bolts is
♦
not available in the vehicle, use the adapter set for tamper-
proof wheel bolts -T10101- .
♦ If the adapter is not available, a new replacement adapter can
only be obtained via the code number.
The adapter code number to loosen and tighten the anti-theft
♦
wheel bolts is stamped on the front side of the adapter.
Special tools and workshop equipment required
Golf 2004 ➤ , Golf Plus 2005 ➤
Maintenance - Edition 11.2009
4. Descriptions of work
113