Checking The Brake Disc; Removing The Brake Disc - APRILIA Atlantic 500 Workshop Manual

Cycle parts

CHECKING THE BRAKE DISC

CAUTION
The following operations must be performed when
the brake disc is installed on the wheel.
Visually check the surface of the brake disc. If it
shows any signs of scoring or damage, replace the
disc (REMOVING THE BRAKE DISC).
Check the wear of the brake disc by measuring its
minimum thickness with a micrometer at several
points.
If the minimum thickness of the disc, even at one
point, is less than the prescribed limit, replace the
disc.
Minimum thickness of the brake disc: 3.5 mm (0.137
in)
With a dial gauge, check that the disc oscillation does
not exceed the allowed tolerance. Replace if neces-
sary.
Brake disc oscillation tolerance: 0.1 mm (0.004 in)

REMOVING THE BRAKE DISC

Read through the paragraph (PRECAUTIONS AND
GENERAL INFORMATION).
Take down the front wheel (REMOVING THE FRONT
WHEEL).
Remove the five brake disc screws (7).
CAUTION
When refitting, apply LOCTITE ® 270 over the
threads of the brake disc screws.
Remove the brake disc.
7-36
Release 00 2002-09
Atlantic 500
chap. 7