Periodic Maintenance Operations
REMOVING THE BATTERY COVER
Read through paragraph BATTERY.
NOTE
Put the vehicle on a solid and flat surface
•
Make sure the ignition lock switch is turned to " ".
•
Lift the saddle, see (UNLOCKING/ LOCKING THE
SEAT).
•
Remove the mat from the helmet compartment.
•
Unloose and remove the two screws (1).
•
Remove the battery cover from the bottom (2)
paying attention to the upper tangs (3).
•
Disconnect the electrical connector (4) of the
helmet compartment light.
•
Remove the battery cover (2)
CHECKING AND CLEANING THE TERMI-
NALS
•
Remove the battery cover, see (REMOVING THE
BATTERY COVER).
•
Make sure that the cable terminals (5) and the
battery terminals (6) are:
–
in good conditions (and not corroded or covered
with deposits);
–
covered with neutral grease or Vaseline.
If necessary:
•
Disconnect first the negative (–) and then the
positive cable (+).
•
Brush with a wire brush to eliminate any sign of
corrosion.
•
Reconnect first the positive (+) and then the
negative cable (–).
•
Cover the terminals of the cables and of the
battery with neutral grease or Vaseline.
WARNING
Tighten the clamp screws.
2-6
Release 00
2002-09
4
3
2
1
5
6
chap. 2
Atlantic 500