Electrical Equipment
INJECTION RELAY CONTROLS
To verify that the relay is working:
•
Remove the seat, see (REMOVING THE SEAT).
•
Supply a 12 V tension to the two male terminals
(85-86).
•
With a multimeter (in ohm meter mode) verify the
continuity between the other two terminals (87-
30).
Correct value with supply to the relay: 0 Ω Ω Ω Ω Ω
Correct value without supply to the relay: ∞ Ω Ω Ω Ω Ω
If the resulting values do not correspond to those
prescribed, replace the relay concerned.
CAUTION
For the main injection relay only:
Observe the polarity supplying terminal (86) with
the "+" and terminal (85) with the "-", as in the
interior there is a diode.
6-6
Release 00
2002-09
Atlantic 500
chap. 6