Electrical Equipment
WATER THERMISTOR CHECK
See (COOLANT THERMISTOR FUNCTION CHECK)
on page 6-14.
FAN RELAY CHECK
To verify that the relay is working:
•
Remove the seat, see (SEAT REMOVAL).
•
Supply the two male terminals (85-86) with a 12V
tension.
•
With a multimeter (set to ohm meter mode) verify
the continuity between the other two terminals (87-
30).
Correct value with supply to the relay: 0 Ω Ω Ω Ω Ω
Correct value without supply to the relay: ∞ Ω Ω Ω Ω Ω
If the resulting values do not correspond to those
prescribed, replace the relay concerned.
6-20
Release 00
2002-09
Atlantic 500
chap. 6