Horizontal Beam Adjustment; Replacing The Fuses - APRILIA Atlantic 500 Workshop Manual

Electrical Equipment

HORIZONTAL BEAM ADJUSTMENT

• Remove the internal front shield, see (INTERNAL
FRONT SHIELD REMOVAL).
To carry out the beam adjustment:
• Use the special handle (as indicated on the
diagram) from the front of the vehicle.
• Turn CLOCKWISE and the beam will move to the
RIGHT (with respect to the direction faced).
• Turn ANTICLOCKWISE and the beam will move
to the LEFT (with respect to the direction faced).

REPLACING THE FUSES

Carefully read (MAINTENANCE).
CAUTION
Do not repair faulty fuses.
Never use fuses different from the recommended
ones.
The use of unsuitable fuses may damage the
electric system or, in case of short circuit, may
even cause a fire.
NOTE
If a fuse blows frequently, there probably is a
short circuit or an overload in the electric system.
• If an electric component does not work or works
irregularly, or if the engine fails to start, it is
necessary to check the fuses.
• Check the 3 A and the 15 A fuses first and then
the 20-30 A fuse.
To carry out the checking:
• Remove the battery cover, see (BATTERY
COVER REMOVAL) or remove the front hood, see
(FRONT HOOD REMOVAL).
• Extract the fuses one by one and check if the
filament (1) is broken.
• Before replacing a fuse, try to find out the cause of
the trouble, if possible.
• Then replace the damaged fuse with a new one
having the same amperage.
NOTE
If you use one of the spare fuses, put a new
fuse in the appropriate seat.
• Replace the battery cover, see (BATTERY
COVER REMOVAL) or replace the front hood, see
(FRONT HOOD REMOVAL).
6-38
Release 00 2002-09
4
2
3
5 6
8
7
chap. 6
Atlantic 500
1
9