Checking The Transmission Oil Level And Topping Up - APRILIA Atlantic 500 Workshop Manual

Periodic Maintenance Operations
NOTE
Make sure the above procedures are carried
before the engine oil level is checked
• Unscrew and remove cap/dipstick (1).
• Unloose and remove the engine oil cartridge filter
(3).
WARNING
Do not use the vehicle if lubrication is insufficient.
Never use unsuitable or contaminated lubricants
as they accelerate the wear and tear of moving
parts and can cause irreparable damage.
WARNING
The used oil contains substances that are to the
detrimental of the environment. Dispose of the
used oils in compliance with the regulations in
force.
• Unloose and remove the oil drain plug (4) to allow
the engine oil to flow out completely.
• Fit a new oil cartridge filter (3) after having lubri-
cated the relative O rings.
• Screw and tighten the engine oil drain plug (4).
• Pour in about 1700 cm
through the filling hole (2).
• Screw and tighten the oil dipstick (1).
• Start the vehicle and let the engine run for a few
minutes. Switch it off and allow it cool down.
Check the engine oil level again with dipstick (1). If
necessary, top up without exceeding the MAX
mark.
Top up and change the oil using SAE synthetic oil
5/W 40 exceeding the API ST specifications.
CHECKING THE TRANSMISSION OIL LEVEL AND
TOPPING UP
Read through the paragraphs LUBRICANTS, MAIN-
TENANCE AND TABLE OF LUBRICANTS.
NOTE
Put the vehicle on a solid and flat surface
• Put the vehicle on the central stand.
WARNING
The engine and the components of the exhaust
system become very hot and remain hot for some
time after the engine has been stopped. Before
handling these components, wear insulating
gloves or wait until the engine and the exhaust
system have cooled down.
2-14
3
(103.7 cu.in) of engine oil
Release 00
3
2002-09
Atlantic 500
1
2
4
1
chap. 2