VERTICAL ADJUSTING OF THE
HEADLIGHT BEAM
To rapidly check the correct direction of the
beam, place the vehicle on flat ground, 10
m away from a wall.
Turn on the low beam, sit on the vehicle
and make sure that the beam projected on
the wall is slightly under the horizontal line
of the headlight (about 9/10th of the total
height).
To adjust the headlight beam:
Turn the appropriate screw (1) with a
screwdriver.
By TURNING IT CLOCKWISE, you set
the beam upwards.
By TURNING IT ANTICLOCKWISE, you
set the beam downwards.
! "
HORIZONTAL ADJUSTMENT
OF THE HEADLIGHT BEAM
Remove the front inner shield, see p. 54
( R E M O V I N G T H E F R O N T I N N E R
SHIELD).
Unscrew and remove the two screws
(2).
NOTE
Depending on the adjustment to
be carried out, the screws (2) must be
replaced with longer ones (supplied in kit).
Position
the
appropriate
(supplied in kit) between the headlight
fastening points and the front outer
s h i e l d , a c c o r d i n g t o t h e t y p e o f
adjustment to be carried out.
NOTE
Use fastening screws suitable for
the selected spacers.
Insert and tighten the two screws (2).
use and maintenance Leonardo 125 - 150 - 250 - 300
$
spacers
61