Rotary Knob; Switches - Magnum Energy ME Series Operator's Manual

ME Series Remote Control - Front Panel
The remote control is equipped with a wide range of easy-touse switches
and displays, allowing you to quickly setup your inverter/charger as
well as determine its operational status.

Rotary Knob

The Rotary "spin" knob is similar to a dash radio knob and used to easily move
between menus to select program options. Turn t h e r o t a r y k n o b c lo c k w i s e
t o i n c r e a s e s e l e c t i o n s a n d c o u n t e rclockwise to decrease selections. Push
the knob to "save" the selection displayed in the LCD screen.

Switches

Inverter ON/OFF:
Used to switch the inverter function ON and OFF. The green
"INVERTER" LED turns ON and O F F w i t h t h e s w i t c h .
Charger ON/OFF:
Used to switch the charger function ON and OFF. The green "CHARGER"
LED turns ON and OFF with the switch. Press and hold the switch
down for 5 seconds to initiate EQ.
Soft Keys:
Press the soft keys to access the required function. Then use rotary
"SELECTOR" knob to scroll through the selections. Press the rotary
knob to save the selection. Options include:
Shore –
Sets the appropriate breaker size for the incoming shore power and is used
to control the amount of AC amps the battery charger uses from HOT 1 IN.
Selection options are 5,10,15,20,30 and 50 amps.
AGS –
Turns the optional AGS (Auto Gen Start) function ON and
OFF. Selection options are OFF, ENABLE and TEST.
M e t e r s –
This function is display only and indicat e s D C v o l t s , D C
amps, AC volts (future) and AC amps (future).
Ó 2003 - Magnum Energy, Inc.
3. Operation,
continued
5