Event Menu - Safety Vision SVR-4100 User Manual

Event Menu

The Event Menu contains pa-
rameters that control connected
sensor inputs and how events are
recorded.
Sensor
The Sensor menu controls each
sensor input that triggers events.
The SVR-4100 supports up to eight
inputs and can configure each one
individually.
Use the remote control to
configure the following for each
individual input:
ENABLE: Select ON to enable this
sensor for input. Select OFF to disable
it.
NAME: Press Enter on the remote
control to display an on-screen
keyboard and enter the name for this
sensor here.
OSD: Press Enter on the remote
control to display an on-screen
keyboard and enter an abbreviated
or truncated name of the sensor
here. This name appears in the OSD
while viewing the Live View, or when
searching for or reviewing recorded
events.
SET: Select LOW for low to high
(normally closed, NC), or select HIGH
for high to low (normally open, NO).
ALARM: Select ON to enable the
ALM LED on the front of the SVR-
4100 when a sensor is triggered and
marks video as "R" so that it can be automatically downloaded (see page 13). This
LED continues to flash after an event is triggered until the configuration menus are
accessed.
LOG: Select YES to enter events triggered by this sensor into the log file (a file that
cannot be deleted) and all this event to be searched for when reviewing videos.
LOCK: Select ON to lock the video of the event recorded when this sensor is
triggered (not allowing it to be overwritten).
A sensor must be installed and wired
properly to the SVR-4100 in order
for it to function properly. For more
information see the Installation
section.
33