Safety Vision SVR-4100 User Manual page 38

SvR-4100 USeR gUide
For more information about
connecting the SVR-4100 to a vehicle
speedometer, please contact Safety
Vision Technical Support.
ALARM: Select ON to enable the ALM LED on the front of the SVR-4100 when the
THRESHOLD speed is reached and an event is triggered. This LED continues to flash
after an event is triggered until the configuration menus are accessed.
LOCK: Select ON to lock the video of the recorded event when the THRESHOLD
speed is reached (not allowing it to be overwritten).
Speed
The Speed menu controls the speed type
(SPDL and SPDO) events.
Use the remote control to configure the
following options:
SPEED SOURCE: Select VEHICLE to
obtain vehicle speed data from the
vehicle's own speedometer, or GPS to
obtain this data from the GPS signal.
SPEED: Select MPH to use miles per hour
or KPH to use kilometers per hour.
ALARM SETTING: Select the following
options for LOWSPEED and OVERSPEED:
ENABLE: Select ON to enable this SPEED
event. Select OFF to disable it.
THRESHOLD: Use the number keys on
the remote control to enter the speed at
which the event is triggered.