Event Menu; Sensor - Safety Vision RouteRecorder 4C SD SS User Manual

Event Menu

Sensor

The Sensor menu controls each
sensor input that triggers events. The
RouteRecorder 4C SD SS supports up
to eight inputs and can configure each
one individually.
Use the remote control to configure
the following for each individual input:
ENABLE: Select ON to enable this
sensor for input. Select OFF to disable
it.
NAME: Press Enter on the remote
control to display an on-screen
keyboard and enter the name for this
sensor here.
OSD: Press Enter on the remote
control to display an on-screen
keyboard and enter an abbreviated
or truncated name of the sensor
here. This name appears in the OSD
while viewing the Live View, or when
searching for or reviewing recorded events.
SET: Select LOW for low to high (normally closed, NC), or select HIGH for high to low
(normally open, NO).
ALARM: Select ON to enable the ALM LED on the front of the RouteRecorder 4C SD
SS when a sensor is triggered and marks video as "R" so that it can be automatically
downloaded (see page 13). This LED continues to flash after an event is triggered
until the configuration menus are accessed.
LOG: Select YES to enter events triggered by this sensor into the log file (a file that
cannot be deleted) and all this event to be searched for when reviewing videos.
LOCK: Select ON to lock the video of the event recorded when this sensor is
triggered (not allowing it to be overwritten).
A sensor must be installed and wired
properly to the RouteRecorder 4C SD SS
in order for it to function properly. For
more information see the Installation
section.
33