Connector Communication - Denso BHT-700QWB-CE User Manual

3.4.1 Connector Communication

Depending on the computer interface to which the BHT is being connected, or the communcation unit
used, the user can choose between an RS-232C, USB or Ethernet connection.
Place the BHT on the communication unit (CU-733, CU-714) and transmit data.
Requests
Handling the CU-714
• A Category 5 (Cat 5) LAN cable or higher is required when using the CU-714 in 100BASE-TX networks.
Successful communication may not be possible with other cables.
• Do not forcibly insert the LAN connector or pull the cable strongly. Failure to observe this may result in
damage to the connector or cable.
• The MAC address is written on the nameplate on the rear of the CU-714.
The BHT-700 RS-232C interface has no signal line for ActiveSync connection, and therefore ActiveSync
connection via RS-232C cannot be used.
CU-733: RS232C or USB
CU-714: Ethernet
2D Code Handy Terminal
39