Table of Contents
Advertisement
[2] TRIGGER SETTINGS
Tap "2:TRIGGER SETTINGS" at the Detail screen to allow the read mode
to be set when performing a Code scanning test.
AUTO OFF:
Auto-off mode
MOMENTARY:
Momentary switching mode
ALTERNATE:
Alternate switching mode
CONTINUOUS: Continuous reading mode
Auto-off mode (F):
If you press the trigger switch, the illumination LED comes on. When you release the switch or when the
BHT completes barcode reading, then the illumination LED will go off. Holding down the trigger switch
lights the illumination LED for a maximum of 5 seconds.
While the illumination LED is on, the BHT can read a barcode until a barcode is read successfully or the
barcode devices file becomes closed.
If the illumination LED goes off after 5 seconds from when you press the trigger switch, it is necessary to
press the trigger switch again for reading a barcode.
Once a barcode is read successfully, pressing the trigger switch cannot turn on the illumination LED and
the BHT cannot read the next barcode as long as the entered barcode data is not read out from the
barcode buffer.
Momentary switching mode (M):
Only when you hold down the trigger switch, the illumination LED lights and the BHT can read a barcode.
Until the entered barcode data is read out from the barcode buffer, pressing the trigger switch cannot turn
on the illumination LED so that the BHT cannot read the next barcode.
Alternate switching mode (A):
If you press the trigger switch, the illumination LED comes on. Even if you release the switch, the
illumination LED remains on until the barcode device file becomes closed or you press that switch again.
While the illumination LED is on, the BHT can read a barcode.
Pressing the trigger switch toggles the illumination LED on and off.
Once a barcode is read successfully, pressing the trigger switch turns on the illumination LED but the BHT
cannot read the next barcode as long as the entered barcode data is not read out from the barcode buffer.
Continuous reading mode (C):
If this mode is specified, the BHT turns on the illumination LED and keeps it on until the barcode device
file becomes closed, irrespective of the trigger switch.
While the illumination LED is on, the BHT can read a barcode.
Once a barcode is read successfully, the BHT cannot read the next barcode as long as the entered
barcode data is not read out from the barcode buffer.
Code scanning test settings are valid only while performing code scanning tests.
− Note −
Settings are initialized when a code scanning test is terminated.
2D Code Handy Terminal
99
Advertisement
Table of Contents
